When to Use an X-bar / Range Chart

SPC Software displays X-bar / Range chart

An X-bar & Range Chart with process capability estimates from SPC IV Excel software.

X-bar / Range charts are used when you can rationally collect measurements in groups (subgroups) of between two and ten observations. X-Bar / Range charts can be easily created using SPC software or (for special use in Gage R&R studies) gage calibration software. Each subgroup represents a "snapshot" of the process at a given point in time. The x-axes are time based, so that the charts show a history of the process. For this reason, you must have data that is time-ordered; that is, entered in the sequence from which it was generated. If this is not the case, then trends or shifts in the process may not be detected, but instead attributed to random (common cause) variation.

For subgroup sizes greater than ten, use X-bar / Sigma charts, since the range statistic is a poor estimator of process sigma for large subgroups. In fact, the subgroup sigma is ALWAYS a better estimate of subgroup variation than subgroup range. The popularity of the Range chart is only due to its ease of calculation, dating to its use before the advent of computers. For subgroup sizes equal to one, an Individual-X / Moving Range chart can be used, as well as Moving Average, EWMA or Cu Sum charts.

X-bar Charts are efficient at detecting relatively large shifts in the process average, typically shifts of +-1.5 sigma or larger. The larger the subgroup, the more sensitive the chart will be to shifts, providing a Rational Subgroup can be formed. For more sensitivity to smaller process shifts, use a Moving Average, EWMA or Cu Sum chart.